Jigsaw Circle Cutting Compass: Cutting Perfect Discs and Radii in Timber

Achieve perfectly round discs and cutouts with your jigsaw using steel compass rod attachments and narrow scroll blades.

Published by: Sierras de CalarLast reviewed on 2 min estimated read
Jigsaw tracing a circular arc using a central pivot point on a timber workpiece

Cutting round holes or circular tabletops freehand invariably leads to distorted edges. Fitting a compass guide bar or building a trammel arm yields pristine circular cuts every time.

Table of Contents View sections
  1. Preventing Blade Wandering in Circular Radii
  2. Mandatory Scroll Blades
  3. Top 3 Methods for Cutting Circles
  4. Critical Precautions
  5. Frequently Asked Questions

Preventing Blade Wandering in Circular Radii

Wide straight-cutting blades bind against the inner curve when tracing a radius, forcing the blade to tilt outward. Using a narrow scroll blade (under 5mm spine width) lets the tool rotate smoothly on its axis without binding.

Mandatory Scroll Blades

  • Bosch T 101 AO Clean for Wood: Narrow 4.5mm profile and pointed teeth for pristine curved cuts in laminated and decorative boards.
  • Bosch T 244 D Speed for Wood: Narrow blade with aggressive side-set teeth for rapid curve cuts in construction timber.

View Bosch T101AO scroll blades on Amazon UK →

Top 3 Methods for Cutting Circles

1. Steel Compass Rod Attachments

Insert your jigsaw’s parallel rip fence in reverse and drop the center pivot pin into your layout center point. Tighten the thumb-screws to lock the exact millimeter radius.

Find jigsaw circle cutting guides on Amazon UK →

2. Workshop Plywood Trammel Arm

For large circular tabletops (600mm to 1500mm), screw the jigsaw shoe to a 6mm plywood strip with a center pivot pin anchored in your bench.

3. Drilling Entry Holes with Forstner Bits

For internal cutouts, bore a clean 15mm hole on the waste side with a Forstner bit so the blade enters without disturbing the perimeter.

Check Forstner drill bit sets on Amazon UK →

Critical Precautions

  • Verify the power lead or extraction hose won’t wrap around the center pivot.
  • Support the center disc with masking tape or wedges near the end of the cut to prevent blade pinching.

Frequently Asked Questions

Can you cut circles without orbital pendulum action?

Yes, orbital action should always be turned to 0 when cutting curves or circles to avoid blade twisting.

Back to Guides Overview